Instructions for use HIV + Syphilis blood test

Please read this manual carefully and completely before taking your sample. Do not hesitate to contact us if you have any questions.

Activate your kit

Non-activated kits cannot be processed in the lab, so please follow the instructions below.

  1. Just before taking the sample, visit https://kits.abel.care/.
  2. Enter the barcode and verification code found on the activation card. You will find that card in the SOA care box. Once you have scanned the QR code, this step is complete.
  3. Follow all the steps as prompted on the website.
  4. While activating the kit, you can choose to have your report forwarded to your doctor.

Sample collection

This kit contains a TASSO collection device, a test tube, a de-stamping cloth, a sticker, instructions, a biosafety bag and a return envelope.

  1. Place all items on a clean surface in front of you. Make sure paper towels are within reach.
  2. The best place to take the sample off is the side of your arm at the level of your upper arm. Remove any excess hair.
  3. Open the packaging of the TASSO sampling device
  4. Unscrew the cap from the test tube and press the tube hard onto the TASSO device.
  5. Warm your upper arm by rubbing up and down with your hand for 30 seconds.
  6. Then rub your arm from left to right for 30 seconds to further warm the arm. This improves blood flow and facilitates blood sampling.
  7. Clean the site with the disinfectant wipe.
  8. Remove the plastic cover that sits over the red button from the TASSO device.
  9. Remove the plastic sticker from the other side of the TASSO device and stick the device to the collection site.
  10. Press the red button firmly to start the blood collection. Do not be alarmed, this does not hurt. It is important to press firmly.
  11. The blood will flow into the tube from now on. Note that this may take 5 minutes.
  12. The test is complete when the blood is filled to the top line of the tube.
  13. Remove the TASSO device and place the adhesive tape on the small wound to prevent further bleeding.
  14. Remove the tube from the TASSO device by a small twisting pull.
  15. Click the cap on the tube.
  16. Turn the tube up and down 10 times by making a twisting motion with the tube between your thumb and forefinger.
  17. Put the tube in the biosafety bag

Packaging and sending your samples

  1. Place the tubes in the Labo Maenhout bag that you will find in the STD care box and seal it tightly.
  2. Remove everything from your STD care box and place only the Labo Maenhout bag with the samples in the empty box. Close the box securely.
  3. You will find the return sticker among the items. Place the box containing the samples back in the original shipping bag, close the bag and attach the return sticker to the shipping bag.
  4. Go to the nearest bpost (Belgium) / DHL (Netherlands) / LaPoste (France) letterbox and deliver the parcel there. (Parcel is already pre-addressed and pre-paid).
  5. Within 2 to 3 working days you will receive an e-mail from us (check your junk mail) that you can view your result online at https://kits.abel.care/results.

! ! ! Make sure you drop the parcel in the mailbox on the day you take the test. This date must correspond to the date entered when you activated your parcel ! ! !