Instructions for use STD Anal Test

Please read this manual carefully and completely before taking your sample. Do not hesitate to contact us if you have any questions.

Activate your kit

Non-activated kits cannot be processed in the lab, so please follow the instructions below.

  1. Just before taking the sample, visit https://kits.abel.care/.
  2. Enter the barcode and verification code found on the activation card. You will find that card in the SOA care box. Once you have scanned the QR code, this step is complete.
  3. Follow all the steps as prompted on the website.
  4. While activating the kit, you can choose to have your report forwarded to your doctor.

Sampling

  1. Take off the bottom garments. Wash your hands thoroughly before starting.
  2. Partially pull open the packaging of the cotton swab without touching the cotton side of the swab. 

    IMPORTANT: Do not touch the cottony side of the swab and do not put the swab down. Touching the cottony tip, laying the swab down or dropping the swab may affect the accuracy of the result.
  3. Hold the cotton swab in the middle of the swab (shaft) between thumb and forefinger and carefully remove the swab from the container. Do not lay it down.
  4. Insert the cotton swab, cotton side up, 5 centimetres into the anus and move the cotton swab in small circles (for 30 seconds) so that the swab touches the anus wall.
  5. Remove the cotton swab from the anus.
  6. While still holding the swab, carefully unscrew the cap from the tube of liquid. Do not spill the contents of the tube.
    Immediately place the swab in the tube so that the soft end of the swab is visible under the label of the tube.
  7. Carefully break the shaft of the cotton swab at the score line (the notch in the middle of the swab), being careful not to spill the liquid in the tube.
  8. Close the tube. Make sure you have tightened the cap properly.
  9. Discard the remaining part of the cotton swab.

Packaging and shipping of your samples

  1. Place the tubes in the Labo Maenhout bag that you will find in the STD care box and seal it tightly.
  2. Remove everything from your STD care box and place only the Labo Maenhout bag with the samples in the empty box. Close the box securely.
  3. You will find the return sticker among the items. Place the box containing the samples back in the original shipping bag, close the bag and attach the return sticker to the shipping bag.
  4. Go to the nearest bpost (Belgium) / DHL (Netherlands) / LaPoste (France) letterbox and deliver the parcel there. (Parcel is already pre-addressed and pre-paid).
  5. Within 2 to 3 working days you will receive an e-mail from us (check your junk mail) that you can view your result online at https://kits.abel.care/results.

! ! ! Make sure you drop the parcel in the mailbox on the day you take the test. This date must correspond to the date entered when you activated your parcel ! ! !